-ADVERTISEMENT-

Not only is Aaron Flournoy’s Ram that you see on these pages a daily driver, it’s currently his wife’s daily driver. Since Aaron is bigger than us, we decided to not make fun of him, but the point was proven; you can have insane power and a completely usable truck at the same time. This type of all-around performance and reliability didn’t come easy to Aaron however; it was a path he had to take over many years, and one that resulted in many broken parts along the way.

“After adding a little more fuel and perfecting his launch, Aaron got what he wanted, a timeslip that read 10.93 at 123 mph.”

Early Changes

Aaron’s story starts the same as many other diesel owners. He bought a 2006 Dodge Ram 2500 because he needed a good all-around vehicle, and what’s better than a truck that gets good fuel economy and has some torque, right? Well, soon that Dodge had a programmer, intake and exhaust. Next came a 62mm turbocharger, some bigger injectors, a lift pump, and a transmission soon on its way out. With the help of Mat Ray at Siskiyou Diesel Performance, the stock Dodge 48RE received numerous upgrades from one of the most well-known companies in the business: Sun Coast Transmissions. The transmission was rebuilt by Mat using a Sun Coast flexplate, valve body, and billet input, output and intermediate shafts. The converter was also upgraded to a low-stall unit that would be good for towing, since Aaron only had the 62mm turbocharger. With a built transmission now installed, Aaron put down an impressive 595 rear-wheel horsepower. Hey, this diesel stuff was easy!

After his initial success, Aaron knew he couldn’t stop building his truck. He was just having too much fun with it. So in went a second CP3, larger injectors, and a set of twins. Then, in 2010, came just a wee bit of a setback. The truck had a slight miss at about 1,600 rpm, and when Aaron and Mat did a compression test, they found it was almost 100 psi down on cranking pressure on some cylinders. It turned out that two rods had bent, and the other four were well on their way. Rather than try to slap something back together, Aaron decided on a full rebuild, so he could have something reliable at that power level.

New Beginnings

The engine was sent off to Mike Braun Automotive Associates in Redding, California, for machine work, and then was assembled by Aaron and buddy Ed Maxey. The bottom end received a set of ARP main studs along with a girdle, and shot-peened 12-valve connecting rods replaced the bent stockers. The pistons were factory Cummins pieces that were coated. Finally, the bottom end was completely balanced and blueprinted. The rest of the engine was upgraded too, with a Stage 3 Colt camshaft bumping up the valves a little higher, and a set of ARP 625 head studs clamping a ported 5.9L head with titanium valve seats firmly down onto the block. The power-producing parts remained the same as before the engine mishap, although Aaron now went with a much more scientific approach with tuning, using EFILive software to tune his ride with custom tunes from Silver Bullet Tuning.

“With low 11-second timeslips and 868 rear-wheel horsepower, Aaron was happy with his truck for the next few years…”

The Payoff

With low 11-second timeslips and 868 rear-wheel horsepower, Aaron was happy with his truck for the next few years, with a supportive wife, friends and family putting more than 40,000 miles on the new engine. Then, in 2014, Aaron decided to step things up a bit, and try to break into the 10-second zone. After adding a little more fuel and perfecting his launch, Aaron got what he wanted, a timeslip that read 10.93 at 123 mph. We don’t know what the future holds for Aaron and his white rocket, but after building a 10-second daily driver, we don’t know what else he has to prove.

 

the 5.9L Cummins in Aaron's Dodge

With more than 40,000 miles above 850 rwhp, the 5.9L Cummins in Aaron’s Dodge is a testament to a well-built diesel’s reliability. A bottom-end girdle with main studs, shot-peened 12-valve rods and coated pistons ensure the short block is reliable for years to come.

-ADVERTISEMENT-
A big part of the common rail's power comes from compound turbos that were assembled by Jefferson State diesel using MPI piping.

A big part of the common rail’s power comes from compound turbos that were assembled by Jefferson State diesel using MPI piping. The small 62/71/13 turbo was retained, but a 80mm S400 was added under it to make the big power numbers. The 80/96/1.32 a/r turbo combines with the small charger to produce 85 psi total boost.

A PPE Dual Fueler mounts a second pump up on top of the engine, and gives the common rail system a fighting chance of maintaining rail pressure. The diesel fuel goes from both pumps to highly efficient Flux 4 injectors from F1 Diesel, which are a big piece in the 900-rwhp power number.

A PPE Dual Fueler mounts a second pump up on top of the engine, and gives the common rail system a fighting chance of maintaining rail pressure. The diesel fuel goes from both pumps to highly efficient Flux 4 injectors from F1 Diesel, which are a big piece in the 900-rwhp power number.

A Snow Performance water-methanol injection system

A Snow Performance water-methanol injection system runs straight water along with two large 625-ml nozzles. The water is a big help at the track, where it reduces EGT from a borderline 1,600 degrees EGT to a safe 1,400 degrees. Aaron also uses the water when towing.

ARP 625 head studs and an O-ringed head

If the Cummins engine has a weakness, it’s keeping head gaskets alive. Aaron’s Ram fixes this with top of the line ARP 625 head studs and an O-ringed head, which keep cylinder pressure in the engine, where it should be.

48re transmission

Underneath the truck is a 48re transmission that was assembled nearly 60,000 miles ago by Siskiyou Diesel Performance. The automatic has Sun Coast Converters internals, as well as a Sun Coast flexplate, and low-stall triple-disc converter that was designed for towing.

the AirDog 150-gph lift pump

Aaron is pushing the limits of what the AirDog 150-gph lift pump can provide, but so far it’s been keeping up with both CP3s and the injectors and maintaining rail pressure.

The performance modifications to Aaron's Ram weren't just limited to the engine and transmission.

The performance modifications to Aaron’s Ram weren’t just limited to the engine and transmission. The rearend still has the factory limited slip and 3.73 gears, but the suspension has been modified with Ride Rite air bags and Bilstein 5100 shocks.

The interior of Aaron's Dodge is mostly stock, save for a full complement of ISSPRO gauges.

The interior of Aaron’s Dodge is mostly stock, save for a full complement of ISSPRO gauges. With three on the A-pillar, two more on the steering column, and one in the dash, fuel pressure, rail pressure, boost, trans temperature, drive pressure, and exhaust gas temperature are all kept under careful watch.

a healthy exhaust system

With plenty of power on tap, a healthy exhaust system is needed to allow a free flowing exit of all that turbo pressure. A 5-inch system from Magnaflow starts at the turbo, and extends all the way to the back of the truck.

The rear of the truck has been lowered 3 inches, while the front remains stock.

The rear of the truck has been lowered 3 inches, while the front remains stock. Moto Metal 962 20×12-inch wheels were also added to give the truck some flair.

Awesome 1.59 60-foot times come in a good part thanks to extra-long Superlift traction bars

Awesome 1.59 60-foot times come in a good part thanks to extra-long Superlift traction bars, which plant the rear wheels hard at the track.

Nitto 420S tires are used for both track and street use.

Nitto 420S tires are used for both track and street use. Aaron runs normal pressure when street driving, but at the track airs down to 30 psi in the front and 25 psi in the rear for optimal traction.

automatic side steps from AMP Research

So friends and family all of shapes and sizes can easily get in to the truck, automatic side steps from AMP Research were installed on the Dodge.

Drive A 900-HP Cummins

A 900-HP Cummins